Function Selection - Mitsubishi Electric Mr.SLIM PCY-P18KA Operation Manual

7. Other Functions
7.2. Error Codes indication
If you have entered contact number to be called in the event of a problem, the screen displays this number.
(You can set this up under Function Selection of remote controller. For information, refer to section 8.)
If the ON lamp and error code are both blinking: This means that the air conditioner is out of order and operation has been stopped (and cannot re-
sume). Take note of the indicated unit number and error code, then switch off the power to the air conditioner and call your dealer or servicer.
ERROR CODE
˚C
˚C
Error Code
If only the error code is blinking (while the ON lamp remains lit): Operation is continuing, but there may be a problem with the system. In this case,
you should note down the error code and then call your dealer or servicer for advice.
* If you have entered contact number to be called in the event of a problem, push the Check button to display it on the screen. (You can set this up
under Function Selection of remote controller. For information, refer to section 8.)

8. Function Selection

Function selection of remote controller
The setting of the following remote controller functions can be changed using the remote controller function selection mode. Change the setting when
needed.
Item 1
1. Change Language Language setting to display
( " C H A N G E L A N -
GUAGE")
2. Function limit (1) Operation function limit setting (operation lock) ("LOCKING
("FUNCTION SELEC- FUNCTION")
TION")
(2) Use of automatic mode setting ("SELECT AUTO MODE")
(3) Temperature range limit setting ("LIMIT TEMP FUNCTION") • Setting the temperature adjustable range (maximum, minimum)
3. Mode selection (1) Remote controller main/sub setting ("CONTROLLER MAIN/
( " M O D E S E L E C - SUB")
TION")
(2) Use of clock setting ("CLOCK")
(3) Timer function setting ("WEEKLY TIMER")
(4) Contact number setting for error situation ("CALL.")
4. Display change (1) Temperature display °C/°F setting ("TEMP MODE °C/°F")
("DISP MODE SET-
(2) Room air temperature display setting ("ROOM TEMP DISP
TING")
SELECT")
(3) Automatic cooling/heating display setting ("AUTO MODE
DISP C/H")
When the Check button is pressed:
CALL:XXXX
XXX:XXX
ON/OFF
Item 2
ERROR CODE
Error Code Indoor Unit No.
Indoor Unit's Refriger-
ant Address
Alternating Display
ON/OFF
Item 3 (Setting content)
• Display in multiple languages is possible
• Setting the range of operation limit (operation lock)
• Setting the use or non-use of "automatic" operation mode
• Selecting main or sub remote controller
* When two remote controllers are connected to one group, one con-
troller must be set to sub.
• Setting the use or non-use of clock function
• Setting the timer type
• Contact number display in case of error
• Setting the telephone number
• Setting the temperature unit (°C or °F) to display
• Setting the use or non-use of the display of indoor (suction) air tempera-
ture
• Setting the use or non-use of the display of "Cooling" or "Heating" dis-
play during operation with automatic mode
ON lamp
(Blinking)
ON/OFF
11