Channel Setup - Panasonic Omnivision PV-V4620 Operating Instructions Manual

Timer Recording Using VCR Plus+ System (continued)
Manual VCR Plus+ System |
Channel Setup
¢ Before you begin, complete "Channel Setup
Preparations" below right.
Important Note
* If your VCR connection type changes from type A to B on
page 14, repeat steps 1-4 of page 15 and select VCR >
CABLE/DSS » TV before proceeding with these steps.
Do "Auto VCR Plus+ System Channel
Setup (Part 1)," steps 1-3 on page 16.
Select MANUAL SET.
VCR Plus+ CH SET UP
1) Press AV
AUTO SET to select.
2) Press >
to set.
SELECT:4 ¥ KEY
SET 7» KEY
END ¿ACTION KEY
IMPORTANT NOTE:
For step 3, use the list you prepared. You may leave
lines blank if you don't receive that station, or if the
GUIDE CH number and the RECEIVE CH numbers
are the same.
Select VCR Plus+
VCR Plus+ CH SET UP
GUIDE CH RECEIVE CH channels.
1) Press >
> EN to move
cursor to
SELECT:4 Y KEY right
SET :» KEY
END 'ACTION KEY column.
2) Press AW to change
VCR Plus+ CH SET UP RECEIVE CH number.
3) Press <4 to set.
4) Press AY to scroll
GUIDE CH RECEIVE CH
> 01
02 up/down GUIDE CH
SELECT:A Y KEY column.
SET ;4 KEY d e e a d e
: ¢ Repeat step 3 until list is
END :ACTION KEY complete.
To make corrections,
Press AV and > to move to error, then AV to change,
or ADD/DLT* to erase number.
Yo
End setup.
Press ACTION
| three times.
» Make each entry within 5 minutes or the VCR will exit this mode,
+ Once local channels have been programmed, they will stay in
memory, even in the case of a power failure.
18
Process of Recording
. BACON
Connection| => [EMB =>
Programming
ECT LIGHT
2 SELECT/
Á ACTION
3 ADD/
DELETE
PAUSE (A SKIP SPEEG oft
O aj MA SKIP
SÓ O
Channel Setup Preparations
in order to complete step 3 left, make a
local channel list (see example below).
You will need the following:
» A line up of normal TV and/ or Cable stations and
the channel number you receive them on.
+ A list of Guide (VCR Plus+) channel numbers for
the stations you receive found in TV Guide and
selected newspapers.
1 Make a 3-column chart. In the left column, write
the name of all the stations you receive.
2 In the middle column, write each station's Guide
(VCR Plus+) number from TV Guide.
3 In the right column, write the channel number
your TV receives the station on.
EXAMPLE ONLY
Assigned | Channel no.
Broadcast or Guide your TV
Cable (VCR Plus+) | receives the
Station Name | channel no. station on
Nickelodeon | 38 | 20 |
| CBS |
04
For assistance, call 1-800-211-PANA(7262).