Control Feature - Panasonic Omnivision PV-V4620 Operating Instructions Manual

Multi-Brand Control Feature
The Remote Control may be set up to control some TV or Cable/DSS Receiver functions.
Multi-Brand Control Setup
Find your TV, Cable or DSS Receiver Brand
Code Number on following page.
ta arar 3 POWER
Setup for TV Setup remote.
Hold down TV and enter code 2 Wor
with NUMBERED keys. DSS/ CABLE
Setup for Cable or DSS
Hold down DSS/CABLE and
COO) enter code with NUMBERED keys.
( DSS y OOO ry NUMBERED
CABLES and e For code 100 or greater, press the É keys
seam eS 100 key first, then remaining digit.
© E.g. for 102, press 100, then press 0,
and then press 2.
unit on or off.
« See table below for tist of
controllable functions in each mode.
| Notes) + Please repeat Multi-Brand Control setup after replacing remote
control batteries.
¢ The remote control will not operate all TVs, Cable Boxes, and
DSS receivers made by manufacturers listed. If you get no
results, your particular brand cannot be controlled.
Using the Multi-Brand Control
After remote control is setup, you can select VCR, TV, or DSS/CABLE for the desired function.
Press VCR or TV or DSS/CABLE on the remote control.
This table shows which buttons are available for each mode.
Available
Buttons VCR TV
CABLE/ DSS
EJECT, SAP/Hi-Fi, POWER, INPUT,
cD In TV or DSS/ CABLE mode, it may be necessary to press ENTER after pressing NUMBERED keys for channel selection.
CABLE/ DSS
DISPLAY, FF, REW, NUMBERED keys,
TAPE POSITION, C/A SKIP
VCR/TV, PLAY, STOP
EJECT, SAP/Hi-Fi,
DISPLAY FF, REW,
PAUSE/SLOW, REC,
SPEED, COUNTER RESET
TAPE POSITION, C/A SKIP
VOL UP/ DOWN POWER, ENTER,
NUMBERED keys
(except 100key),
CH UP/ DOWN
20 For assistance, call 1-800-211-PANA(7262).