Error Codes - Midea MLV47R5BWW User's Manual & Installation Instructions

Error Codes

Your washer is equipped with an automatic error-monitoring system to
detect and diagnose problems.
Error
Possible Cause
Code
Your washer takes more than
30 minutes to fill with water at
low water level, 45 minutes at
medium water level, or 60 minutes
E1
at high water level. After water
finishes entering your washer, the
water level has not changed in
10 minutes.
The unit takes more than 10
E2
minutes to drain.
E3 The lid is open.
The unit is out of balance in spin
E4
operation.
The unit is out of balance in spin
E5
operation.
F5 Load sensing failed
F8 Load sensing failed
Fd Door lock failed
Notice:
1. LED display: when an error occurs, Turbo LED will flash and the wash
process LEDs will indicate an error code
2. O - off, - blink,

3. When an error occurs. Please refer to troubleshooting guide or
installation instructions and try again. If error codes persist, call for
service.
- Lighting
●
Solutions
Check if the lid is open. Check
Troubleshooting guide for, "No
water or not enough water" Check
for water leakage.
Check Troubleshooting guide for
"Does not drain or spin"
Close the lid. See Installation
instructions to, "Level your washer".
The door lock or PCB may have
failed, try steps again. Call service
center.
Check Troubleshooting guide for,
"Excessive vibration or noise". See
Installation instructions to, "Level
your washer".
Adjust the washer level refer to
installation instructions. If situation
continues, call service center. Call
service center.
Call service center.
Call service center.
Call service center.
37