Error Codes - Midea MLV43A3AWW User's Manual & Installation Instructions

Error Codes

Your washer is equipped with an automatic error-monitoring system to
detect and diagnose problems.
ERROR
POSSIBLE CAUSE
CODE
Your washer takes more
than 30 minutes to fill
Washer. Or when the water
level sensor does not

detect water level change
after water is flowing for
5 min.
The unit takes more than 10

minutes to drain.
The lid is open. Or the

washer is not level.
Your washer is out of
balance more than three

times during a spin
operation.
Notice:
1. LED display: when an error occurs, Extra Rinse LED will flash and the
wash process LEDs will indicate an error code
2. O - off, - blink,

3. When an error occurs. Please refer to troubleshooting guide or
installation instructions and try again. If error codes persist, call for
service.
- Lighting
●
SOLUTIONS
• Make sure that the lid is
not open.
• Make sure that water is
not leaking. See No water
or not enough water on
page 26.
• See Washer does not
drain on page 27.
• Close the lid.
• Level the washer. See
"Step 4: Level your
washer" on page 19.
• See Washer vibrates or is
too noisy on page27 .
• See Washer vibrates or is
too noisy on page27 .
37