Midea MLV47R5BWW User's Manual & Installation Instructions page 35

Problem Solution
•
When washer
has excessive
vibration or
noise
•
•
•
•
•
•
Washer stops
•
•
•
•
•
•
Lid is locked or
will not open
•
•
•
Make sure that your washer is set on a level surface.
If the surface is not level, adjust your washer's feet to
level your washer.
Make sure that your washer is not touching any other
object.
Make sure that the laundry load is balanced.
During the spin process, if clothes are piled to one
side of the tub, your washer may stop because
of the imbalance. Your washer tries up to three
times to solve the problem automatically. If the
washer cannot solve the problem, try to manually
redistribute clothes inside the tub.
Check to make sure packaging pieces of base foam
cushion are not stuck under washer.
Make sure that the power outlet is a working outlet.
Check the fuse or reset the circuit breaker.
Close the lid, then press the Start Pause button to start
your washer. For your safety, your washer does not spin
unless the lid is closed.
Before your washer starts to fill, it makes a series of
clicking noises to make sure that the lid is locked. The
washer doesn't drain after the lid locks. For automatic
cycles: Before filling, and after the lid locks, a load sensing
program starts. Washer will agitate clothing without water
to determine load type, water level, and cycle time. Then
it fills. This can take up to one minute. Its normal. For non
automatic cycles the washer fills after the lid locks.
Sometimes your washer may pause between stages in the
cycle. Wait to see if your washer starts again.
Disconnect the inlet hoses and clean the screens
periodically. The hose filter screens may be clogged.
Press the Start Pause button to pause the washer.
You cannot open the lid if the washer is running.
After you pause the washer, it may take a few
seconds for the lid lock to release.
If the lid is locked when your washer is not running,
press the Power button to turn on your washer.
If power fails while your washer is running, when
power is restored, the lid unlocks. Your washer waits
three minutes then runs the rest of the cycle.
35