Advertisement
Select the digital output to be output from the optical
digital audio output connector of DECK.
Press ACTION
to display DVD MAIN MENU.
DISC
lANGUAGES
Illll=
[
/
..............
TV
MODE
:4:3
Pan&Scan
PROGRESSIVE
OUT:OFF
SELECT
:A
•
SET
:SET
END
:ACTION
Press AV
to select
"AUDIO OUTPUT,"
and
press SET
to display screen.
Press Jl, V
to select an item,
and
press SET
repeatedly
for
output. (See below.)
• "LPCM (DVD)" selections
OFF:
Linear PCM of less than 48 kHz/16 bit is
output. When playing DVDs recorded
in linear
PCM of over 48 kHz/20 bit, no digital audio is
output.
(Factory preset)
PCM: When playing DVDs recorded
in linear PCM of
48 kHz/20 bit/24 bit or more, digital audio
converted
to 48 kHz/16 bit is output.
(Digita_ output of PCM audio is restricted to
48 kHz/16 bit or below for copyright
protection.)
• "Dolby
Digital"
selections
Bitstream:
Dolby Digital bitstream (1 ch - 5.1 ch)
is output. (Factory preset)
PCM: When you have connected an amplifier that
doesn't have a bui_tqn Dolby Digital decoder.
• "dts"
selections
Bitstream:
DTS bitstream
is output. (Factory preset)
PCM: When you have connected an amplifier that
doesn't have a built-in DTS decoder.
•
"DRC
(Dynamic
Range
Compression)"
selections
OFF:
Normal audio range is selected. (Factory preset)
ON:
For dynamic sound even at low volume,
this is useful for late-night listening.
[Dolby Digital DVDs only].
I_Ready
Checklist
[]
DECK is in DVD mode, press DVD.
Type of amplifier
to be connected
Recommended
setting
LPCM
Dolby
DTS
(DVD)
Digital
No amplifier is connected
AV amplifier (with digital
audio input connector)
PCM
PCM .1
PCM .1
without Dolby Digital/DTS
decoder
AVamplifierincluding
PCM
Bitstream
PCM
Dolby Digital decoder
AV amplifier including
DolbyDigital/DTSdecoder
PCM
Bitstream
Bitstreanl"
• Make settings according
to amplifier
connected
to optical audio output as
shown in above table.
"1 When connecting
an amplifier
(with an
optical digital input connector)
which
does not contain the Dolby Digital or
DTS decoder,
be sure to select
"PCM'.
If "Bitstream"
is selected,
starting
DVD play may cause such a
high level of noise as to be harmful to
your ears and damage
the speakers.
*2 When a dts decoder is connected,
please
select "Bitstream"
in "dts."
If "PCM" is selected,
there will be
stereo
sound.
When a Dolby Digital decoder
is
connected,
please
select "Bitstream"
in "Dolby Digital."
If "PCM" is selected, there will be
stereo
sound.
Press ACTION to redisplay DVD MAIN
MENU and go to step 2 to setup another
item.
Or, press ACTION twice to exit.
53
Advertisement
