Installation; Tools Needed - jbc ALE-908VA Manual

Installation

Before you can start working, the solder reel* must be attached and
the tool stand, the soldering iron and the power cord connected to
the control unit.
Follow the assembly steps in this P&P Guide.
Note: The solder diameter must match the ALE model purchased.
Make sure the solder wire diameter is compatible with the wheels
already installed in the ALE control unit.

Tools Needed

The required tools are located on the control unit.
Spanner Allen Key Ø 1,5
Step 1
Solder Reel Assembly
Loosen the reel locking screw (1) and remove the reel locking from
the axis (2).
Assemble the solder reel onto the axis (3).
Assemble the solder reel in such a way - when viewed from above -
that the solder wire unwinds on the dispensing mechanism side (4).
Then pass the solder wire through the wire guidance (5).
Solder Wire
4
*Solder reel is not included.
Allen Key Ø 2,5
5
4
Solder Wire
Unwinding
Solder Wire
Direction
Guidance
Solder Reel
Wheels (inside)
Soldering Iron
Reel Locking
Screw
1
Solder Wire
Guidance
Watch the
product
assembly video
Tool Stand
Axis
2
Reel Locking
3
Solder Reel
Solder Wire