Maintenance - Freemotion GZFM6014.3 Owner's Manual

MAINTENANCE

For safe and trouble-free operation of your FreeMotion Fitness
routine preventative maintenance on a regular basis. Make sure that all parts are properly tightened each time
the strength machine is used. Replace any worn parts immediately. The strength machine can be cleaned with a
damp cloth and a mild, non-abrasive detergent. Do not use solvents.
Note: Instruct all personnel to perform equipment inspection and maintenance requirements. Personnel must
record and report any accident. For any questions or concerns, see HOW TO CONTACT CUSTOMER CARE
on the back cover of this manual.
Use only original FreeMotion Fitness parts for repair or replacement to maintain your machine's warranty.
FreeMotion Fitness recommends the following procedures:
SCHEDULED MAINTENANCE
DAILY
1. Towers and Frames:
• Wipe with a light solution of mild soap and warm
water. Rinse and dry thoroughly.
Important: Do not use abrasive cleaners
because they may scratch the equipment. Strong
cleansers and abrasives will damage decals. Use
caution around decals. Do not use solvents such
as lacquer thinner, kerosene, gasoline, or similar
liquids.
CAUTION: When using any cleaning product, try
it first in an inconspicuous place to ensure there
is no damage to the material. Follow directions
and adhere to safety precautions of each manu-
facturer of cleaning agent used. FreeMotion
Fitness and its vendors cannot be held liable for
damage or injuries resulting from the use or mis-
use of cleaning products.
2. Stainless Steel Covers:
• Wipe with a light solution of mild soap and warm
water. Rinse and dry thoroughly.
® strength equipment, it is important to perform
• If desired, or to remove corrosion, use available
commercial stainless steel polishing com-
pounds. Follow manufacturers' instructions.
3. Handles:
• Check all straps for wear.
• Visually check each strap along the full length
for signs of wear such as cuts, tears, or nicks.
Replace the strap immediately if necessary.
• A "fuzz" will appear on straps over time and is
not a concern unless it appears to be worn
through strands of the weave.
4. Straps with Rings:
• If a ring is pulling through the strap or tearing
away from the edge of the strap, replace the
strap immediately.
• Check stitching points on straps for tears, worn
spots or separation. Replace the strap if neces-
sary.
7