Fisher & Paykel 7 Series User Manual page 35

Wash problems
PROBLEM
Wash cycle time
longer than usual
Small amount of
water in drum at end
of cycle
Liquid remaining
in fabric softener
dispenser at end of
cycle
Creasing
TROUBLESHOOTING
POSSIBLE CAUSES
If water pressure is low, cycle
time will increase due to longer
fill times.
The out of balance automatic
recovery setting may be set to 3.
Wash cycle time is approximate
and may be affected by a
number of factors including load
size, water pressure, and which
options are selected.
A small amount of water may
discharge from the fill nozzle
after a wash.
After flushing the dispenser,
a small amount of water may
remain in the dispenser at the
end of the cycle.
Dispenser may be blocked.
Overloading of the washer.
Inappropriate cycle selection.
Spin speed too high.
Wash temperature too high
for items.
Other.
WHAT TO DO
Ensure that inlet hose filters are
not blocked.
Refer to 'Option Adjustment Mode'.
Refer to 'Wash cycles'.
This is normal.
This is normal.
Try cleaning your fabric softener dispenser
to remove any blockages, refer to 'Care and
Cleaning'.
Try reducing load size.
Choose as this cycle has been
EASY IRON
designed to minimise creasing.
Try selecting a lower spin speed.
Try selecting a lower wash temperature.
Sort your load so that items of similar
weight are washed together.
Do not leave wet clothes to sit in the
washer or laundry basket.
35