H3C S5500-EI Series Security Configuration Manual page 81

Add the switch to IMC as a portal device:
3.
Select User Access Manager > Portal Service Management > Device from the navigation tree to
a.
enter the portal device configuration page. Then, click Add to enter the page for adding a
portal device, as shown in
Click Add.
b.
Configure the following parameters:
c.
Enter NAS as the device name.
Enter 192.168.1.70 as the IP address of the interface on the switch that uses the portal service.
Enter portal as the key, which must be the same as that configured on the switch.
Set whether to enable IP address reallocation. Because direct portal authentication is used in
this example, select No from the Reallocate IP list.
Click OK.
d.
Figure 23 Adding a portal device
Associate the portal device with the IP address group:
4.
Click the Port Group Information Management icon
a.
Click Add.
b.
Configure the following parameters:
c.
Enter the port group name.
Select Portal_user as the IP address group. The IP address used by the user to access the
network must be within this IP address group.
Leave the default settings in other fields.
Click OK.
d.
Figure 23.
62
for the access device NAS.