H3C S5500-EI Series Security Configuration Manual page 76

Figure 16 Network diagram
Configuration prerequisites
Configure IP addresses for the devices as shown in
other.
Configuring the RADIUS server
This example assumes that the RADIUS/portal server runs on IMC PLAT 5.0 (E0101), IMC UAM 5.0
(E0101), and IMC CAMS 5.0 (E0101).
Add the switch to IMC as an access device:
1.
Log in to IMC, click the Service tab, and select User Access Manager > Access Device from the
a.
navigation tree.
Click Add.
b.
Configure the following parameters:
c.
Set the shared key for secure authentication and accounting communication to expert.
Specify the ports for authentication and accounting as 1812 and 1813, respectively.
Select LAN Access Service as the service type.
Select H3C as the access device type.
Select the switch from the device list or manually add the switch whose IP address is 10.1.1.2.
Leave the default settings in other fields.
Click OK.
d.
NOTE:
The IP address of the access device specified here must be the same as the source IP address of the RADIUS
packets sent from the switch, which is the IP address of the outbound interface by default, or otherwise the
IP address specified with the nas-ip or radius nas-ip command on the switch.
Figure 16 and make sure devices can reach each
57