VESTEL SMART NFY 600 User Manual page 59

PROBLEM
Motor is continuo-
usly working.
An ice layer is
developing in the
section.
Interior tempera-
ture is too low.
Water drips on the
ground.
Light is not opera-
tional.
CAUSE
Motor works more under the
following cases: When the tem-
perature is set to a higher value
than necessary
When large amounts of hot food
are placed
Ambient temperature is very high
Doors left ajar for a very long time
or opened frequently.
After the installation of the app-
liance or when it is left non-
operational for a longer time.
Air holes might be blocked.
Temperature might be set to low.
Water tray (located at the back
on the bottom side) level setting
might not be set properly or the
discharge opening (under the
front face of the compressor bin)
might be not properly placed as to
guide the water into this tray or the
water outlet might be completely
blocked.
LED lamp might be damaged.
Control system might be deacti-
vated the lights since the door is
left open for a long time.
SOLUTION
This is quite normal.
Check that the air holes are not
blocked by the food and place
them inside the appliance with
sufficient space around allowing
proper ventilation. Ensure that the
door is closed firmly. Refer to the
section "Cleaning and Maintenan-
ce" to remove ice.
Increase the temperature by refer-
ring to "Usage" section.
You might need to move your
appliance from the wall to check
the tray and discharge opening.
Refer to Changing the LED lamp
in the Cleaning and Maintenance
section.
Close the door and reopen it to
activate the lights again.
26