Weber Summit E-470 Owner's Manual page 30

SIDE BURNER MAHNTENANCE
WARNING: All gas controls and supply valves should be in
the "OFF" position.
Make sure black wire is connected between the igniter and electrode.
Make sure white wire is connected between the igniter and grounding clip.
Spark should be a white/blue color, not yellow.
1) Igniter Wire
2) Ground wire
3) Burner
Side Burner Grate --
Side Burner cap ----.__
Side Burner Ring & Head --_
Igniter Electrode
Control Knob
Igniter
(3)
PROBLEM CHECK
CURE
Rotisserie burner does not light. Did you hold the burner control knob in and Try to relight burner by holding burner control knob in and continue holding in until
hold in for 20 seconds until after burner 20 seconds after burner has ignited.
ignited?
Did you wait to see the entire ceramic surface When relighting burner by holding burner control knob in, wait to see the entire
become alight before counting 20 seconds? ceramic surface become alight before counting 20 seconds?
Did you repeatedly use the snap ignition until After waiting five minutes for gas to clear, try repeatedly using the snap igniter until
the burner ignited? the burner ignites (refer to "Lighting the Rotisserie Burner").
Does the igniter work (Do you see a spark I Try manually lighting the burner (refer to "Lighting the Rotisserie Burner"). Call
when you repeatedly use the snap igniter? customer service.
If probmems cannot be corrected by using these methods, pmease contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com ®.