Weber Summit E-470 Owner's Manual page 15
Hide thumbs
Also See for Summit E-470:
- Owner's manual (154 pages) ,
- Manual (2 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
Available languages
Available languages
2) Remove the two screws that secure the control panel to the frame.
3) Remove the control panel.Tilt
panel forward and lift up and away from grill. Be careful
not to break or disconnect
the wires for the control panel lights.
Rest the control panel against the left side of the grill (A) exposing the valves, burners,
igniter, and manifold.
(A
.o" iiiii_
CHECK THE FLEXIBLE
HOSE TO MANIFOLD CONNECTION
The natural gas hose has been attached during the manuafacturing
process. We
do recommend
that the hose to gas manifold connnection
be leak tested, following
guidelines
in this Owner's Guide, prior to barbecue operation.
CHECK FOR GAS LEAKS
DANGER
Do not use an open flame to check for gas leaks. Be sure
there are no sparks
or open flames
in the area while you
check for leaks. Sparks or open flames will result in a fire or
explosion
which can cause serious bodily
injury or death and
damage to property.
.....
i!i!i! iii!
iiiiiiiii!!i
!iii!ii!!i
III i i
WARNING:
You should
check for gas leaks every time you
disconnect and reconnect a gas fitting.
Note: All factory-made
connections
have been thoroughly
checked
for gas leaks. The
burners have been flame-tested.
As a safety precaution
however, you should recheck
all fittings for leaks before using your WebeK gas barbecue.
Shipping
and handling
may loosen or damage
a gas fitting.
WARNING:
Perform these leak checks even if your barbecue
was dealer or store assembled.
You will need: a soap and water solution, and a rag or brush to apply it.
Make sure side burner is off (See LEAK CHECK PREPARATION).
Remove valve
control knob and screws. Remove porcelain top.
To perform
leak checks: Slide back the collar of the quick disconnect
(1). Push male
fitting of the hose into the quick disconnect,
and maintain pressure. Slide the collar
closed (2). If it does not engage or lock, repeat procedure.
Gas will not flow unless the
quick disconnect
is properly engaged.
Turn on gas supply.
Check for leaks by wetting the connections
with the soap and water solution and
watching for bubbles.
If bubbles form or if a bubble grows, there is a leak.
Note: Since some leak test solutions,
including
soap and water, may be slightly
corrosive, all connections
should be rinsed with water after checking
for leaks.
WARNING:
Do not ignite burners
when leak checking.
Advertisement
Table of Contents
