Step 1 Preparing Tile Power Supply - Sony DCR-TRV6 Operating Instructions Manual

Step 1 Preparing the power supply
When you use your camcorder fbr a long time, we recommend that you power it Dora a
wall outlet using tile AC power adaptor.
(1) Open the DC IN jack cover, pulling the cover out a little and rotating it.
Connect the AC power adaptor supplied with your camcorder to the DC IN
jack on your camcorder with the plug's • mark f_acing the lens side.
(2) Connect the power cord to the AC power adaptor.
(3) Com_ect the power cord to a wall outlet.
2, 3
PRECAUTION
The set is not disconnected fl'om the AC power source (house current) as long as it is
connected to the wall outlet, even if tile set itself has been turned off-
Notes
• Tile AC power adaptor can supply power even if the battery pack is attached to your
camcorder.
• Tile DC IN jack has "source priority." This means that tile batte W pack cannot supply
any power if the power cord is connected to tile DC IN jack, even when tile power
cord is not plugged into a wall outlet.
Using a car battery
Use Sony DC Adaptor/Charger (not supplied).
14