Viessmann VITOCELL 140-E Installation And Service Instructions Manual page 33

Fitting the thermal insulation jacket
2. 3.
Fig. 30
1. Attach 6 clip fasteners at the back of the cylinder to
the edges of the right and left sections of the ther-
mal insulation jacket. Leave the clip fasteners in
the first notch. Place the thermal insulation jacket
around the cylinder body.
2. Attach the thermal insulation in front of the pipes.
3. Fit the clip fasteners evenly spaced behind the
Solar-Divicon and between Solar-Divicon and Vito-
trans.
Heating water buffer cylinder with Vitotrans and with Solar-Divicon
(cont.)
1.
5.
4.
4. Push the clip fasteners as close together as possi-
5. Install the immersion heater EHE or seal the hole
ble.
with a closure.
33