Viessmann VITOCELL 140-E Installation And Service Instructions Manual page 20

Heating water buffer cylinder with Vitotrans and without Solar-Divicon
Fitting the thermal insulation
2.
4.
Fig. 14
1. Attach 6 clip fasteners at the front of the cylinder to
the edges of the right and left sections of the ther-
mal insulation jacket. Leave the clip fasteners in
the first notch. Place the thermal insulation jacket
around the cylinder body.
2. Fit 4 clip fasteners above and 2 clip fasteners
behind the Vitotrans so that they are evenly
spaced. Leave the clip fasteners in the first notch.
20
(cont.)
1.
3.
3. Push the clip fasteners as close together as possi-
ble.
4. Install the immersion heater EHE or seal the hole
with a cover.