Viessmann VITOCELL 140-E Installation And Service Instructions Manual page 12

Heating water buffer cylinder without Vitotrans and without Solar-Divicon
Fitting the thermal insulation
Danger
Intense heat from a naked flame will melt the
thermal insulation. The resulting vapours may
be harmful to health.
Prevent the thermal insulation from coming into
contact with naked flames, e.g. when welding
and brazing.
!
Please note
If fleece remnants from the thermal insulation
get into the heating water buffer cylinder, they
will contaminate the heating water and may
result in operating faults.
During installation, ensure that no fleece rem-
■
nants enter the heating water buffer cylinder
through the cylinder connections.
■ Seal connections that are not required with
caps.
6x
2.
4.
5.
6x
Fig. 5
1. Attach clip fasteners at the back of the cylinder to
the edges of the right and left sections of the ther-
mal insulation jacket. Leave the clip fasteners in
the first notch. Place the thermal insulation jacket
around the cylinder body.
12
6x
1.
3.
6x
Note
2 people are required for the following work.
2. Attach clip fasteners at the front of the cylinder to
the edges of the right and left sections of the ther-
mal insulation jacket. Leave the clip fasteners in
the first notch.
3. Push the clip fasteners at the back of the cylinder
as close together as possible.