Table of Contents
Advertisement
5A. 4-Post Rack Installation with Standard Rails
Locate the mounting hardware and rack rail assemblies shown below
Step 1
Locate the two adjustable standard rack
rail assemblies.
n
Insert the tabs on the front section of
the adjustable rack rail assembly through
the openings in the rear sections of the
assemblies.
n
Check to make sure the adjustable rack
rail assemblies are connected correctly,
then slide the front section forward and
the rear section back to keep them from
coming apart. These assemblies adjust
to accommodate different rack depths.
Step 2
n
Insert a cage nut into each of the
square holes in the rack you will be
using as shown (three in the front
and two in the rear). They click into
place.
n
Attach the rack /rail assemblies to
the rack using two M5 x 12 flat head
screws and cone washers in the front
and back. The convex side of the cone
washers face toward the rack.
n
Make sure the rack / rail assemblies
and screws are aligned in the rack
not only in the front and back, but
are level in height on the left and
right sides for proper alignment for
appliance installation.
INSIGHT DLP SENSOR 310, 310NTC & 310NTF Appliance Hardware Installation Guide
Rack bracket tab
Front section of
the adjustable
rack rail assembly
Empty
hole
Adjustable rack rail assemblies
4-post rack
NOTE:
The installation
procedures for
Sections 6A
and 6B, 4-Post Rack,
below
and on page 9 are for use
with the rails and hardware
provided in your ship kit. If
different style rails are being
used, or if your rack requires
different hardware, refer to
the instructions provided with
your rail's or rack's ship kit.
Rack bracket tabs
Rear section of
the adjustable
rack rail assembly
Empty
hole
Empty
hole
www.insightdlp.com
Page 6
Advertisement
Table of Contents
