Table of Contents
Advertisement
4.
Unpacking the 4-Post Rack Installation Assemblies
Verify that the ship kit includes one of the following installation assemblies
Installation Assembly A: Standard Rail Assemblies with
Mounting Hardware
n
Two power
cords*
n
A set of 4-post rack mounting
(Eight) M5 x 12
Phillips flat head screws
n
A pair of 4-post rack sliding chassis rail rack assemblies that attach directly to the rack
Rack rail assembly, inside view
Rack rail assembly, outside view
Installation Assembly B: Quick Mount Rails (for use in 4-post racks with square holes only)
n
Two power
cords*
n
Two 10-32 x 3/4" Phillips pan head
(Two) 10-32 x 3/4"
Phillips pan head screws
(used to secure the appliance in the rack)
n
A pair of adjustable quick-mount rack rail assemblies (requires no additional mounting hardware or tools)
Quick-mount rack rail assembly, inside view
Adjustable front quick-mount rack rail assembly
Quick-mount rack rail assembly, outside view
INSIGHT DLP SENSOR 310, 310NTC & 310NTF Appliance Hardware Installation Guide
hardware**
(Eight) M5 x 12
(Ten) M5
cone washers
cage nuts
Adjustable front rack rail assembly
(attaches to the front of the rack)
screws**
(attaches to the front of the rack)
(Two) 10-32 x 3/4"Phillips pan head screws
(used to secure the appliance in the rack)
Adjustable rear quick-mount rack rail assembly
(attaches to the rear of the rack)
NOTE:
Use the hardware
supplied with your specific
rack if different from the
hardware supplied in this kit.
*
NOTE:
Only two power cords
will be included in your
ship kit even if you receive
multiple rail kits.
**
NOTE:
There may be
additional mounting
hardware included that will
not be used with this
installation assembly kit.
Adjustable rear rack rail assembly
(attaches to the rear of the rack)
www.insightdlp.com
Page 5
Advertisement
Table of Contents
