INSIGHT DLP SENSOR 310 Hardware Installation Manual page 13

10. Rear Panel Connections
Step 1
Connect the Ethernet cables.
Step 2 Connect any other required cables.
Step 3
Connect the power cords.
Proceed to Section 12, Front Panel Operation
Power Supply Status LED
There is a single bi-color Power Good LED on each power
supply module to indicate power supply status. The LED
operation is defined in the table below.
Power Supply Condition
Output ON and OK
No AC power to both power supplies
AC present / Only 5VSB on (PS off)
AC cord unplugged or AC power lost; with
a second power supply in parallel still with
AC input power
Power supply warning events where the
power supply continues to operate; high
temp, high power, high current, slow fan
Power supply critical event causing a
shutdown; failure, OCP, OVP, fan fail
In normal operation the Power Good LED on Power Supply
Module 1 and Module 2 will be SOLID GREEN. If the power is
down, both LEDs will BLINK GREEN.
INSIGHT DLP SENSOR 310, 310NTC & 310NTF Appliance Hardware Installation Guide
(continued)
3 3
on page 14.
LED State
GREEN
AMBER
1Hz Blinking
AMBER
AMBER
1 1 1
1 1
CAUTION
The power supply is hot-swappable only when you have
a server with redundant power supplies installed. If you
only have one power supply installed, before removing
or replacing the power supply, you must first take the
server out of service, turn off all peripheral devices
connected to the server, turn off the server by pressing
the power button, and unplug the AC power cord from
the server or wall outlet.
NOTE: The server offers redundant, hot-swap capability.
The connections to AC mains should be made in a
manner appropriate to local code and consistent with
customer power distribution with or without redundant
sources.
OFF
OFF
www.insightdlp.com Page 13