Prepare And Assemble The Rack Rails - INSIGHT DLP SENSOR 300 Hardware Installation Manual

6.

Prepare and Assemble the Rack Rails

Step 1
Mounting Hardware Assembly
n Separate the inner fixed chassis rails
from the outer adjustable rack rail
assemblies.
n Pull each inner fixed chassis rail out
as far as possible.
n Depress the release button and
slide the inner rail completely out.
n Put these rails aside for later
installation on the appliance.
Step 2
Rack Rail Assembly
A. In the front, align the front bracket of
the adjustable rack rail assembly with
three holes in the rack. The rack rail
assembly will attach to the rack
behind the holes in the front. Insert
and tighten two of the flat head
screws in the top and bottom holes
as shown in the illustration on the
right. The center hole will remain
empty for later use to secure the
appliance in the rack.
B. Slide the rack rail assembly back to
attach the rear bracket to the rear of
the rack.
C. In the rear, insert and tighten two of
the flat head screws through the top
and bottom holes of the rear bracket
to the rear of the rack. The rear
bracket will attach to the rack behind
the post with the holes.
Repeat steps A, B
other rack rail assembly on the other side
of the rack.
NOTE: Make sure the rail assemblies are aligned
in the rack not only in the front and back but
also on the left and right sides to allow proper
appliance installation.
INSIGHT DLP SENSOR 300 Appliance Hardware Installation Guide
and C to install the
Release button
Inner fixed chassis rail
Adjustable rack rail Adjustable rack rail Adjustable rack rail
assemblies assemblies assemblies
A A A
Angle View Angle View Angle View
A A
4-post rack 4-post rack 4-post rack
Side View Side View
Outer adjustable rack rail assembly
C C
B B B
Angle View Angle View Angle View
C C
4-post rack 4-post rack
Side View Side View Side View
NOTE: Use the hardware
supplied with your specific
rack if different from the
hardware supplied in this kit.
www.insightdlp.com Page 8