2-Post Rack Installation - INSIGHT DLP SENSOR 310 Hardware Installation Manual

Table of Contents

Advertisement

8.

2-Post Rack Installation

Unpack the appliance and locate the mounting hardware
Step 1
Locate the two long and six short rack
brackets that came in your ship kit.
A.
Securely attach the set of short brackets
with the threaded screw holes to the
long bracket in the front as shown.
Use two M4 truss head screws for each
bracket.
B.
Loosely attach one set of the other short
brackets to the long fixed bracket as
shown using one M4 truss head screw on
each bracket. The three holes on the flap
will face toward the back for later
attachment to the 2-post rack.
C.
Loosely attach the remaining set of short
brackets to the long fixed bracket as
shown using one M4 truss head screw
on each bracket. The three holes on the
flap will face toward the front for later
attachment to the 2-post rack.
Step 2
Attach the assembled brackets to the
2-post rack.
A.
Insert two M5 x 12 flat head screws
through the short brackets into the
2-post rack (in the front and back of the
rack as shown) and tighten. Make sure
the brackets are aligned and level in
height, not only in the front and back
but also on the left and right sides.
B.
Tighten each of the single screws on the
small fixed brackets (located on either side
of the rack) to secure the brackets in the
rack and ensure appliance stability.
INSIGHT DLP SENSOR 310, 310NTC & 310NTF Appliance Hardware Installation Guide
C
Small fixed
rack brackets
B
A
A
Small fixed
rack brackets with
threaded holes
Two M4 truss head screws
A
A
M5 x 12 flat
head screws
(two front and
two rear)
B
NOTE:
The following installation
procedures for
Section 9, 2-Post
Rack
are for use with the rails and
hardware provided in your ship
kit. If different style rails are being
used, or if your rack requires
different hardware, refer to the
instructions provided with your
rail's or rack's ship kit.
Long bracket
C
Small fixed
B
rack brackets
One M4 truss
head screw
NOTE:
Once the assembled rails
are attached to the rack, securely
tighten the single screws on steps
B
and C.
A
*
A
B
www.insightdlp.com
Page 10

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dlp sensor 310ntcDlp sensor 310ntf

Table of Contents