1MRK511447-UEN Rev. E
IEC13000060 V1 EN-US
Figure 10:
5.
Select Use the following IP address and define IP address and Subnet mask if the rear port is
used,see
IEC13000062 V1 EN-US
Figure 11:
6.
Use the ping command to verify connectivity with the IED.
7.
Close all open windows and start PCM600.
Switchgear control unit SAM600-IO
Commissioning manual
IEC13000060-1-en.vsd
Select the TCP/IPv4 protocol and open Properties
Figure
11. The IP address must be different from the IP address chosen for the IED.
Select: Use the following IP address
The PC and IED must belong to the same subnetwork for this set-up to work.
© 2017 - 2023 Hitachi Energy. All rights reserved
IEC13000062-1-en.vsd
Section 5
Starting up
29