Connecting The Lhmi Service Kit To Sam600-Io; Removing The Lhmi Service Kit From Sam600-Io - Hitachi Relion SAM600 Commissioning Manual

Section 4
User interface
4.3.5

Connecting the LHMI service kit to SAM600-IO

The following connection procedure must be followed to secure a proper connection and
communication between SAM600-IO and LHMI service kit:
1. Power off SAM600-IO
2. Remove rear cover plate (X402) for the service port on SAM600-IO
3. Connect the service port cable between SAM600-IO and the LHMI service kit
4. Power on SAM600-IO
4.3.6 Removing the LHMI service kit from SAM600–IO
The following removing procedure must be followed to secure a proper detachment between
SAM600-IO and LHMI service kit:
1. Power off SAM600-IO
2. Remove the connection of service port cable between SAM600-IO and the LHMI service kit
3. Attach rear cover plate (X402) for the service port on SAM600-IO
4. Power on SAM600-IO
For more information on LHMI as a user interface, refer to the Operation manual.
22
Connect only a single local PC with PCM600 to the front port. It is only intended for
temporary use, such as commissioning and testing.
National and local electrical safety regulations must always be followed. Working in a
high voltage environment requires serious approach to avoid human injuries and damage
to equipment.
The IED contains components which are sensitive to electrostatic discharge. ESD
precautions shall always be observed prior to touching components.
© 2017 - 2023 Hitachi Energy. All rights reserved
1MRK511447-UEN Rev. E
GUID-3C4A0B11-CA27-4401-9940-C3CB25F5A464 v1
GUID-E3259B10-1E30-46EA-891A-33D75A6AFE6E v1
GUID-F2A7BD77-80FB-48F0-AAE5-BE73DE520CC2 v1
GUID-705B215D-CAB0-4371-BDFF-C6D9DF3096BA v1
Switchgear control unit SAM600-IO
Commissioning manual
M2366-2 v2