Use The Ethernet Interface With A Fiber Connection - Extreme Networks ISW Series Installation Manual

Install Your Switch
•
To connect the copper port to an Ethernet device, use UTP (Unshielded Twisted Pair)
or STP (Shielded Twisted Pair) Ethernet cables.
The pin assignment of RJ45 connector is shown in
Figure 23: RJ45 Connector Pins
Table 7: RJ45 Connector Pin Assignment
Pin
1, 2
3, 6
4, 5
7, 8

Use the Ethernet Interface with a Fiber Connection

For both 100/1000 Mbps fiber speed connections, the SFP slots are available. The SFP
slot accepts the fiber transceivers that typically have an LC connector.
The fiber transceivers have options of multimode, single mode, long-haul, or special-
application transceivers.
Assignment
T/Rx+, T/Rx-
T/Rx+, T/Rx-
T/Rx+, T/Rx-
T/Rx+, T/Rx-
ISW Series Managed Industrial Ethernet Switch Hardware Installation Guide
Use the Ethernet Interface with a Fiber Connection
Figure 23 and
PoE Assignment
Positive VPort
Negative VPort
X
X
Table 7.
45