Cabinet Top Removal - Sanyo M1990FE Service Manual

3.
DISASSEMBLY INSTRUCTIONS (continuea)
Insert the flat-bladed tip of the screwdriver into a slot on the
Cabinet Bottom. Pry the three slots one by one to open the
Cabinet.
Cabinet Bottom
Cabinet Top
NOTE:
Be careful not to scratch the Cabinet with the screwdriver.
Lift the Cabinet Bottom in the direction of the arrow, pull out
the Connector of the Rod Antenna from the Radio Tuner
P.C.Board, and then, remove the Cabinet Bottom.
Reassemble in reverse order.
CABINET TOP REMOVAL
1.
Remove the Cabinet Bottom by following its removal in-
structions and disconnect the two speaker leads.
Detach the Tuning Knob, Volume Control Knobs, Band
Select Switch Knob, Tape Select Switch Knob, Tone Switch
Knob, FM Mode Switch Knob, and the Jack Plate.
Remove the two screws (4 and 5) and detach the Band
Select Lever and the Band Select Plate.
Band Select Lever
Band Select Plate
Band Select Switch
in the direction of the arrow, and then, detach the Cabinet
Top, noting the speaker lead.
. Detach the Function Switch Knob.
NOTE:
After the Cabinet Top has been mounted on the unit, attach
the Function Switch Knob
Reassemble in reverse order.