Pioneer RVD-XG10 Service Manual page 81

6.3.2 [ODD] and [LAMP LIFE] time display
The accumulated time the unit has had the power on and accumulated
lamp usage can be displayed.
To select the menu, press the Right key with [HOUR METER]
highlighted on the initial display of Integrator mode.
[HOUR METER] display
HOUR METER
ODD
LAMP L I FE
The [ODD] value shows the accumulated time the unit has had the
power on (reset is not possible).
The [LAMP LIFE] value shows the accumulated time since it was
reset the Lamp Life menu after the lamp was replaced.
Even upon the initial use, these two values may differ. This occurs
when an examination has been made at the factory with a lamp for
inspection attached. In such a case, the [ODD] value is larger the
[LAMP LIFE] value.
RS-232C commands
When the unit is started up in Integrator mode, the following RS-232C commands become effective by sending the [AJY] command in a
condition other than the [STARTING UP] process until the unit is turned off.
Command
GIT Outputs the values of the [VIVID] mode setting, [ODD] and [LAMP LIFE] via the RS-232C.
IRC ± dd
Adjust [RED CONT.] with [VIVID] selected.
IGC ± dd
Adjust [GREEN CONT.] with [VIVID] selected.
IBC ± dd
Adjust [BLUE CONT.] with [VIVID] selected.
IRB ± dd
Adjust [RED BRIGHT] with [VIVID] selected.
IGB ± dd
Adjust [GREEN BRIGHT] with [VIVID] selected.
IBB ± dd
Adjust [BLUE BRIGHT] with [VIVID] selected.
CLMRST Returns the above parameters to the factory-set values.
After adjusting with the above commands, terminate RS-232C Adjustment mode using the [AJN] command.
[AJY] Enables adjustment via the RS-232C. When the [MENU] key on the remote controller or on the unit is pressed, the adjustments made
the RS-232C are forcibly disabled, and the OSD menu of the unit appears.
[AJN] Terminates the adjustments made via the RS-232C.
5 0 0 0H
1 2 5 0H
:
EX I T
SET SET
Function
RVD-XG10, RVD-XG10ED, RVA-VK10
Restarting Integrator Mode
If the unit is started from Standby status with the improper input
setting, the setting must be changed.
Restart the unit after changing the input setting as follows.
1. Press the [MENU] key to terminate Integrator mode.
2. Select the input to be used.
3. Hold the [SET] key pressed for more than 2 seconds.
When the unit is started up in Integrator mode, you can deactivate/
activate the mode by the operation in step 3 any time before you
turn off the unit. Once the unit has been turned off, repeat the
procedure described in "Activating Integrator Mode."
* The keys, such as [MENU] and [SET], mentioned in the text can
be either those of the remote control or of the unit.
± dd = adjustable range -32 to +31
± dd = adjustable range -32 to +31
± dd = adjustable range -32 to +31
± dd = adjustable range -32 to +31
± dd = adjustable range -32 to +31
± dd = adjustable range -32 to +31
→Integrator mode is activated.
81