RVD-XG10, RVD-XG10ED, RVA-VK10
MAIN ASSY
is on and that Factory
Connect a PC for servicing
to the unit with an
RS-232C cable.
Load the E
using the software of the
PC for servicing.
No
Replace both the MAIN
Replace the MAIN assy.
assy and the optical block.
Connect a PC for servicing
to the unit with an
RS-232C cable.
Turn on the unit and set it
to Factory mode and load
the supplied data.
Perform the gain and bias
adjustments in a dark room.
Perform the ITO
adjustment in a dark room.
76
Replace
the MAIN assy.
Check that the unit
No
Replace the MAIN assy.
mode can be
activated.
Connect a PC for servicing
Yes
to the unit with an
RS-232C cable.
Check that the unit is on
and that Factory mode can
be activated.
2
PROM data
Load the E
using the software of the
PC for servicing.
Remove the E
Check that data
from the defective board
loading is correctly
and attach them to a new
completed.
board.(There are two
2
E
PROMs. Be careful to
Yes
connect the wires according
to the numbering.)
Read out the E
using the software of the
PC for servicing.
Finished.
2
PROM data
2
PROMs
Check that data
No
loading is correctly
completed.
Yes
2
Replace both the MAIN
PROM data
assy and the optical block.
Note: When both the MAIN assy and the optical block are replaced,
adjustments will be completed by following the adjustment
procedure for the optical block only.