Table of Contents
Advertisement
Turning on the light
+ After
turning
on the power,
turn
on
the
Illumination switch (located at the bottom left of
the keyboard).
Illumination
Lights will illuminate in three locations; the
music stand, front panel, and the pedal board.
Cautions when using illumination
When illumination is used for an extended peri-
od, the light bulbs and the metal parts near the
light bulb (see diagram below) will become hot.
Be careful not to touch your hand or leg on
these areas. In particular, be careful of the fol-
lowing four locations.
1. Inside the music stopper
Do not insert your hand from below.
2. Panel illumination light bulb
Do not touch the light bulb or nearby parts.
When closing the lid, be sure to hold the han-
dles.
3. Bulb cover under the keyboard (foot area)
The entire cover will become hot. Be careful not
to touch your leg to this area.
4. Metal portion of lid
After closing the lid, do not touch this area.
Restoring all the factory default settings
Perform the procedure below to return all the
Settings of the AT-90 to those preset by the fac-
tory (when the instrument was new).
* Make sure there is no floppy disk in the disk
drive before carrying out the procedure.
* Turn on the power while holding down the One
Touch Program button.
One Touch
Program
Power
O
*
When you are using the instrument for the very
first time, or it has remained unused for about a
month or so, it will automatically be returned to
the factory default settings when the power
turned on.
13
Advertisement
Table of Contents
