Timer Playback Of Tape; Select The Play Mode - Kenwood MIDl M-85 Instruction Manual

@ Timer playback of tape
1 Switch the power ON.
Press the POWER key
of the amplifier.
2 Select the program setting mode.
@ The program No. indicators (1 to 6) blink.
3 Select the program No. to be used.
Select from 1 to 6.
ENTER
@ The selected program No. indicator blinks.
5 Input the ON time with the numeric keys.
22:45PM :[2],[2], [4], [5]
6 Input the OFF time with the numeric keys.
23:15PM :(2],(3], [1], [5 |
C= T=T*=T=T=]
Notes:
Press within 10 seconds.
Be sure to adjust the present time before proceeding to
the following.
7 Select the PLAY mode.
The timer modes are switched between PLAY and REC every time the
BAND key is pressed.
8 Select the TAPE source.
iran
ie —» ITAPEI—» TUNER —> LAST
The sources are switched every time the BAND key is pressed.
9 Insert a tape and determine the playback
condition.
Select the side(s) to be played and the Dolby NR mode.
@ Timer playback is possible with either Deck A or Deck B.
However, if tapes are placed in decks, playback will begin
from Deck A.
1 0 Activate the execution of the program.
@® Press the EXE. key. tal
® Select the program No. to be executed by pressing the
numeric key under which it is set.
2 $
TUE Tu
@ The selected program No. indicator lights up.
1 1 Adjust the volume and tone.
1 2 Switch the power OFF.
Press the POWER key
of the amplifier.
2. If it is required to modify a program which has already been set, set a new program from the beginning.
cur.
M-85/M-959 (En) 49