6
6-7
Water supply system connection
For a correct connection to the water supply network follow these instructions.
- Always insert a cut-off tap between the appliance and the water supply pipes, in a position that makes it
easy to handle and turn off after use.
- The water supply connector must be of rigid or flexible metal, use piping with proportionate cross-section.
- Check that the water supply pipes do not carry any rust or metal shavings inside the tank; make sure
that no oxides or ferrous deposits remain in contact with the stainless steel for a long period of time since
they produce corrosion (formation of rust). It is advisable to use galvanized pipes and to let the water run
until it is perfectly clean.
In case of corrosion inside the tank, be aware that this is caused by iron oxides or metal shavings inside the
tank for a long period of time and not by the stainless steel itself.
IMPORTANT
If possible, install a filter between the cut-off tap and the appliance; this will prevent ferrous
deposits from going inside the tanks since, if they oxidise, they could damage the stainless steel .
6 .7 .1
Drain pipe connection
The appliance has a floor drain pipe; carry out drain pipe connection using plastic heat-proof pipes (at least
90°C) in compliance with the hygiene regulations applicable in the country where the appliance is to be
installed.
42
Instructions for qualified fitters
GAS PASTA COOKER - LADY 900
© Copyright 2015