Table of Contents
Advertisement
•
The hour meter displays engine hours when the
hour glass symbol is flashing.
•
The display turns off after 5 minutes after the
ignition key is switched to the
The Tine Engagement Display
Electronic Depth Control Screen
There are 2 ways to activate the tine engagement
display:
•
Tap the multi-function switch either up or down to
display the tine engagement meter.
•
Step on the tine ground engagement foot switch.
Figure 21
1. LCD Indicators/Information screen
2. Tine depth status bar
3. Tine depth setting indicator
4. LED status light
A higher number on the status bar
increases the length of the aeration plug and a lower
number decreases it.
Note:
If the plug length is not the desired length, you
may need to adjust the machine to accommodate for
your weight; refer to
Adjusting the Operator Weight
Control Valve (page
23).
LED Status Light
The LED is multi-colored light
21) used to indicate the system status:
•
Solid Green—indicates normal operating activity
•
Blinking Red—indicates an active fault
•
Solid Red—indicates that maintenance is required
position.
OFF
g211731
(Figure
21)
(Figure 20
and
Figure
Maintenance Reminder Screens
The hour meter displays the number of engine
hours until either the engine oil or transmission oil
maintenance is due. When maintenance is due, the
smart controller/electronic depth control displays
flashing icons for an engine oil maintenance alert or
a transmission oil maintenance alert, and the LED
status light displays a steady red light.
•
A maintenance alert occurs when the maintenance
counter reaches zero.
•
If the service is not performed, the maintenance
counter displays time as negative hours to indicate
the number of hours past due for the service (up
to -500 hours).
•
The hour meter switches between the default
screen and the active alert screen.
•
If more than 1 alert is active, the display cycles
between the alerts in the order that they occurred
before cycling back to the default screen.
The maintenance alerts only display when the default
screen has been active for 2 seconds; however, if
the key is moved to the
occur immediately. When the machine is aerating,
the alert screen does not display but the LED status
light remains a steady red.
Service Engine Reminder
The engine-oil service reminder
down from the initial break-in service interval of 5
engine hours and then counts down from 100 hours
for each service interval thereafter.
21
position, the alerts
START
(Figure
22) counts
Figure 22
g030960
Advertisement
Table of Contents
