Federal Signal Corporation DFC Series Manual page 3

Installing the DFC-WC-TAH21 Push Bumper Wire Cover on the 2021+ Chevrolet
Installing the DFC-WC-TAH21 Push Bumper Wire Cover
FASTENERS PRECAUTION: Double-check all fasteners before initial use and periodically in the future
to ensure proper function and safety.
FOR CALIFORNIA RESIDENTS ONLY; PROPOSITION 65 WARNING: Some products may contain
chemicals such as DEHP, which can cause cancer, birth defects, or other reproductive harm. For
more information, go to www.p65warnings.ca.gov.
To install the DFC-WC-TAH21 Push Bumper Wire Cover:
1. Place the wire covers (Items 1 and 2) as shown in Figure 2. Note that the figure is of the driver-side wire
cover (Item 1).
2. Install the supplied hardware as shown in Figure 3.
3. Tighten all hardware to 8 ft-lb.
DFC-WC-TAH21 Push Bumper Wire Cover
Federal Signal www.fedsig.com
Figure 2 Wire cover placement (Driver side shown)
Figure 3 Install hardware
1
6
1
5
4
3
Tahoe
® ®
3