Advertisement
Installing the DFC-WC-TAH21 Push Bumper Wire Cover on the 2021+ Chevrolet
Introduction
This document contains instructions for installing the DFC-WC-TAH21 Push Bumper Wire Cover in a 2021+
Chevrolet Tahoe. This product is to be installed only on the DFC-WC-TAH21 Push Bumper.
Unpacking the Product
After unpacking the product, inspect it for damage that may have occurred in transit. If it has been damaged,
do not attempt to install or operate it. File a claim immediately with the carrier, stating the extent of the
damage. Failure to identify damage before installation could lead to the rejection of any claim. Carefully check
all envelopes, shipping labels, and tags before removing or destroying them. Ensure that the parts listed in
Table 1 are included in the package. If you are missing any parts, contact Federal Signal Customer Support at
1-800-264-3578, 7 a.m. to 5 p.m., Monday through Friday (CT).
THREAD DAMAGE AND GALLING: To prevent thread damage and galling, anti-seize lubricant must
be used on all stainless steel fasteners.
2
Table 1 Kit contents
Item Description
1
Driver Side Wire Cover
2
Passenger Side Wire Cover
3
No. 6-32 x 2-inch Button Head Bolt
4
No. 6 Lock Washer
5
No. 6 Flat Washer
6
No. 6-32 Hex Nut
Figure 1 Kit items
Tahoe
®
Qty.
1
1
4
4
4
4
DFC-WC-TAH21 Push Bumper Wire Cover
Federal Signal www.fedsig.com
®
Advertisement
