Table of Contents
Advertisement
Remove the seal from below the pane. To do this,
6.
pull the seal and remove it upwards. Remove the
pane.
Pull the lower pane diagonally upwards and out.
7.
Never remove the screws that are located on the
8.
right and left of the sheet metal part.
27.4 Fitting the door panes
When fitting the panes, ensure that, on both panes, the
lettering "top right" is not upside down at the bottom
left.
1.
Insert the lower pane with the no. 1 downwards at
an angle.
Insert the middle pane with no. 2 inwards.
2.
Fit the retaining clips onto the right- and left-hand
3.
side of the pane, aligning them so that the springs
are over the screw holes. Screw the retaining clips
in place.
Insert the seal below the pane.
4.
Hold the top pane in both brackets and insert it at
5.
an angle towards the back.
Ensure that the seal does not slip backwards.
Appliance door en
33
Advertisement
Table of Contents
