Table of Contents
Advertisement
7 Disassembly and disposal
7
Disassembly and disposal
7.1
Disassembly
Schmid AG energy solutions strongly recommends that disassembly be carried out by
our specialists. Schmid AG energy solutions assumes no liability for injury, damage to
machinery or buildings resulting from improper disassembly performed by third parties.
Improper disassembly can cause damage to persons and to the building!
Before disassembly, it is essential to disconnect the power supply.
The competent authorities responsible for the operating permit must be informed
immediately.
«1 Safety instructions» must be observed.
7.2
Disposal
If a system is extended or modified, any disassembled system components or subas-
semblies which cannot be reused must be disposed of in accordance with any applicable
regulations. Local regulations for the disposal of equipment, operating media and
system components must be complied with.
The system essentially consists of the following materials:
•
Iron
•
Casting (steel and cast iron)
•
Refractory concrete lining
•
Insulation mats
•
Ash and slag residue
•
Oils and lubricants
We recommend engaging the services of a local waste management company to ensure
the materials are disposed of properly.
Underfeed grate UTSP
1.10 en
WARNING!
i
D-63
Advertisement
Table of Contents
