Table of Contents
Advertisement
Mounting
6.4 Mounting an input or output element on the gearbox shaft
Use the center holes in the shaft end faces.
Use a fitting device to fit the input or output elements.
Figure 6-1
Observe the correct mounting arrangement to minimize stress on shafts and bearings due to
lateral forces.
a
F
Figure 6-2
Procedure
1. Use benzine or a solvent to remove the anti-corrosion protection from the shaft ends and
flanges. Or remove the existing protective skin.
2. Fit the drive input and output elements to the shafts. Lock the elements.
You have now attached the input or output element.
42
Example of a fitting device
Correct
Incorrect
Hub
Force
Mounting arrangement for low stress on shafts and bearings
SIMOGEAR electric monorail gearbox
Operating Instructions, 01/2024, A5E53220855A/RS-AA
Advertisement
Table of Contents
