Advertisement
Pay attention to the direction of blade rotation, a superimposed arrow on the head of the saw
shows the direction of the blade rotation. The teeth of the saw blade should be oriented in the
arrow direction. Choose also a blade with a marking showing the rotation direction to observe.
Use only sharp blades and not damaged. Cracked or twisted blades should be replaced
immediately.
Do not use HSS steel blades. Use only blades that are appropriate for the speed provided. Make
sure that the axis diameter and the axis hole are consistent.
g) Adjusting the mitre angle
h) Adjusting the tilt of the saw head
You can tilt the saw head of your machine from 0° to 45°.
To adjust the tilt, loosen the locking handle of the table (located at the rear of the machine as shown on
the diagram.
Tilt the saw from 0° to 45° to obtain the desired tilt by using the handle.
Once set, tighten the handle firmly.
- Push with your thumb on the locking device of the lower blade
guard so that the blade guard covers the blade.
- Tighten the housing screw of the blade bolt.
- Check the locking device of the lower blade guard is properly in
place and that it properly blocks the latter.
Your saw allows performing mitre cutting from 0° to 45° both
to the right and to the left.
To adjust the table, loosen the locking handle of the table
(A) as shown in the diagram, move the table (C) until you
get the desired angle by using the handle (A).
Finally, lock the table using the locking handle to lock the
table in the proper position.
14
Advertisement
