Advertisement
d) Connection of the dust and chips collector bag
e) Mounting and adjustment of the table extensions
You can use the table extensions to work on long pieces of wood.
These extensions can be placed on the right or left according to your
needs.
Insert the extensions in the notches provided and tighten the locking
screw so that the extensions do not move while using the machine.
f) Installation and change of the blade:
An accessory should be changed when the machine is idle and disconnected.
Insert the dust bag over the extraction outlet located at the rear of
the machine.
You can also connect a vacuum hose to the dust extraction bend to
improve suction. The dust bag should be emptied frequently. The
dust bag is equipped with a zipper to empty it more easily. A full
bag greatly reduces its effectiveness. This bag needs to be cleaned
regularly in soapy water; before reuse, be sure to dry thoroughly.
Caution: Dust particles can cause respiratory problems. For your
protection, wearing a dust mask according to the standards in force
is advisable.
To install or change the blades, your mitre saw should be in raised
position,
- Remove the front screw from the housing of the blade bolt (4).
- Lift the motor block blade and then the lower blade guard as high
as possible (note: take care, the lower blade guard is equipped with
a spring.)
Using the wrench, hold the flange (2) and then loosen the bolt of
the shaft (3) using the Allen key.
- Remove the flange of the blade and install or replace the blade
on the shaft. Make sure that the blade is properly installed, the
teeth directed downwards at the front of the saw.
- Place again the flange of the blade firmly against the blade.
- Tighten the bolt of the shaft by turning it to the left. Using the
wrench, hold the flange and tighten the bolt of the shaft using the
Allen key.
13
Advertisement
