Advertisement
-
Always check if the saw blade guard is working properly. It shall be well assembled, and it shall be
easily moving with hand and that it can be locked when operating the tool (see in instructions for
use).
Laser safety instructions
-
Warning: Do not look directly at the laser beam.
The laser light / laser radiation used on this saw is of class 2 with 1mV at the maximum and the
wavelengths of 650 nm. These lasers do not usually constitute an optical hazard, but stare at the
beam can cause flash blindness. The danger exists if you deliberately look at the laser beam. To
avoid optical hazards, please observe the following guidelines:
o Never point the laser beam at a person or object other than the workpiece.
o The laser cannot be pointed at a person's eye for more than 0.25s.
o Always make sure that the laser beam is directed to a solid piece that does not have a reflective
surface such as a piece of wood or a rough, matte surface. A glossy steel sheet or similar
material is not suitable for use with the laser because a reflective surface can return the laser to
the operator.
o Do not replace the laser light device with a different laser product. Repairs must be performed
by the manufacturer of the laser product or its authorized dealer.
Caution: Use of controls or adjustment or application of procedures other than those specified in
this manual may result in exposure to hazardous radiation.
Residual risks
Warning: When using a power tool, basic safety precautions should be taken to avoid the risk of fire,
electric shock or injury to persons.
Please read the additional safety instructions in this manual carefully and note that even if the
power tool is used in accordance with the operating instructions, it is not entirely certain that all
residual risk factors will be eliminated. The following hazards can occur:
o Contact with blade
o Rebound of the workpiece or debris of the workpiece
-
Fracture of the blade.
-
Ejection of debris from the machined part.
-
Hearing damage if you do not wear ear plugs.
-
Projection of wood chips that are harmful to health when the tool is used in a poorly sealed room.
It is therefore important to take preventive measures:
o Always use a sawdust disposal device if possible.
o Do not use deformed or cracked blades.
o Remove the plug from the power tool before any adjustment or maintenance, including
replacement of the blades.
o Choose a suitable blade for the material to be cut.
o Do not use the saw to cut material other than those designated by the manufacturer
The miter saw can be transported safely by the main handle, but only when it has been
disconnected from the power outlet and locked in the locked position.
Do not use the saw when the guards are not properly assembled, in good condition or properly
maintained.
Make sure that the arm is securely secured during bevel cutting.
Apply the workpiece strongly against the swivel table on which there should be no other pieces of
wood.
Install sufficient lighting.
Make sure you have been trained or trained and know how to adjust and use this tool.
Use blades that are properly sharpened and do not exceed the maximum rated speed.
Do not pick up debris from the cutting area until the blade guard closes and the saw comes to a
complete stop.
7
Advertisement
