Sony Cyber-shot DSC-S40 User's Manual / Troubleshooting page 3

Note:
This equipment has been tested and h)und to
cmnply with tile lindts lor a Clas B digital
device, pursuant to Part 15 ol tile FCC Rules.
These limits are designed to prm ide reasonable
protection against harmlul intml_:rcnce in a
residential installation. This equipment generates.
uses. andcan radiate radio hequency energy and.
il not installed and used in accordance with tile
instr/ictions, may CZlUSe hal-Ulllll interl_r_nce to
radio COlllnlunications. Howe'ver, ther_ is no
guarantee that interlhrence wi]] not occur in a
particular installation. If this equipment does
cau_ harmfifl interlhrence to radio or tclmision
reception, which can be determined by turning the
equipment oil and on, tile user is encouraged to
try to correcl the inlerl_:lellce by olle or u/ore o|
tile lollowing nle_surcs:
Reorient or relocate tile receiving _lntcnniL
Increase tile separation between tile
equipment and receiver.
Connect the equipment into an oullet on a
circuit diflcrenl l]()lll thai 1() which lhe
rcc*$iver is
connected.
Consult tile dealer or an experienced radio/TV
technician lot help.
The supplied intcl_ce cable nlust be u_ed with tile
equipment in order to comply with the limits lot a
digital device pursuant to Subpart B ol Part 15 ol
FCC Rules.
Use a commercially available AC plug adaptor
[a], if necessaly depending on the design of the
wall outlet (wall socket) [b].
AC-LS5K
[a] [hi
The set is not disconnected h'om the AC power
source (mains) as long as it is conneclcd to the
wall outlet (wall socket) even if the set itself has
been turned off.
This product has been tested and lound compliant
with the limits set out in the EMC Directive lot
using connection cables shorter than 3 inelers (9.8
lcet).
Attention
The electromagnetic fields tit tile specific
lrequencies may influence the picture and sound
Of this canlera,
Notice
If static electricity or electronlagnelisnl causes
data translhr to discontinue midway (ldil), restart
tile application or disconnect and connect the
coumnmicafion cable (USB, etc.) again.