Table of Contents
Advertisement
CAUTION
1. The tape-width selector must always be correctly set;
otherwise, the tape will be damaged by the retractable
tape guides when you press the left-hand top key of
the load switch.
2. The supply^clutch lever must always be set perpen-
dicular to the stacker at the end of the supply stacker
loading step; otherwise, the tape will tear or break.
3. Do not push the rotating tab against the take-up
stacker guide when there is tape in the read head;
otherwise, the tape will tear.
Basic 2671
Steps:
2671 \
Steps:
2671 l
Steps:
I
I
1
1
1
1,6, 7, and 9 or 10*
with Center-Roll Feature
I
1
1
•
o
1
1
~I
1 , 3 , 4 , 6 , 7, and 9 or 10*
n/ith Center-Roll Feature ar
o
1
1
id Take-Up Feature
o
1
1
1
1, 3, 4 , 6 , 8, and 9 or 10*
'
2671
Steps
2671
Steps
with Supply Feature
r®;
i
i
i
i
i
1,2, 4, 6, 7, and 9 or 10*
with Supply Feature and Take-Up Feature
o •(•)
I
I
I
I
I
I
1, 2 , 4 , 6 , 8 , and 9 or 10*
Strip Feeding
Strip feeding may take place on all 2671 configurations, except
that if the take-up feature is fitted then the rotating tab on that
feature must be considered. The steps for strip feeding in this
instance are:
1, 5, 6, 7, and 9 or 10*
*
Remote Operation: Step 9
Local Operation:
Step 10
Figure 11. Identification of the Tape Loading Steps
[08275]
Tape Loading, Unloading, and Rewinding 27
Advertisement
Table of Contents
