A
B
Technical data
The dimensions of the shafts must ensure a minimum gap between the outer wall of the smoke duct and the inner wall of the shaft: 30 mm
for circular section shafts and 20 mm in the event of a square section shaft (Fig. 32).
Maximum 2 changes of direction are allowed on the vertical section of the flue system with a maximum clearance angle of 30° with re-
spect to the vertical.
To calculate the length of the flue, simply add, for each component you intend to use, the corresponding value indicated in the
column "Length equivalent to m of pipe" in the table in par. 1.14, and check that the resulting sum is equal to or less than the
maximum length indicated in par. 1.15.
50
Ducting
Rigid
Flexible
Rigid
Flexible
A
C
32
ADAPTOR
(A) mm
Ø 60
66
Ø 50
66
Ø 80
86
Ø 80
103
SHAFT
SHAFT
(B) mm
(C) mm
106
126
106
126
126
146
143
163
C
93
33