Table of Contents
Advertisement
Vertical kit assembly with aluminium slate Ø80/125 (Fig. 26)
To install the kit Ø 80/125 one must use the adapter kit (pos. 2, Fig. 26).
1. Install the flanged adaptor (2) on the central hole of the appliance, positioning gasket (1) with the circular projections downwards in
contact with the appliance flange.
Imitation aluminium slate installation:
2. Tighten the concentric flange with the screws in the kit.
3. Replace the slates with the aluminium sheet (4), shaping it to ensure that rainwater runs off.
4. Position the fixed half-shell (5) on the aluminium slate;
5. Insert the intake-exhaust terminal (7);
6. Fit the Ø 80/125 concentric terminal pipe with the male side (smooth) to the female side of the adapter (1) (with lip seals) up to the end
stop, making sure that the wall sealing plate (3) has been fitted; this will ensure sealing and joining of the elements making up the kit.
7
6
5
4
3
2
1
Extensions for vertical kit Ø 80/125 (L = maximum length)
(Fig. 27).
To calculate the length of the flue, simply add, for each
component you intend to use, the corresponding value
indicated in the column "Length equivalent to m of pipe"
in the table in par. 1.14, and check that the resulting sum
is equal to or less than the maximum length indicated in
par. 1.15.
46
The adaptor kit includes (Fig. 26):
C
33
N°1 Gasket (1)
N°1 Adapter Ø 80/125 (2)
The Ø 80/125 kit includes (Fig.26):
N°1 Wall sealing plate (3)
N°1 Aluminium slate (4)
N°1 Fixed half-shell (5)
N°1 Mobile half-shell (6)
N°1 Concentric intake/exhaust pipe Ø 80/125 (7)
The remaining kit components must not be used
26
C
33
27
Advertisement
Table of Contents
