Table of Contents
Advertisement
CIM Prefix: IMM CIM ID: 0060
User Action:
Complete the following steps until the problem is solved:
1. Reconfigure the watchdog timer to a higher value.
2. Make sure that the XCC Ethernet-over-USB interface is enabled.
3. Reinstall the RNDIS or cdc_ether device driver for the operating system.
4. Disable the watchdog.
5. Check the integrity of the installed operating system.
• FQXSPOS4004I: Operating System status has changed to [arg1].
Operating System status change
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0191
User Action:
Information only; no action is required
• FQXSPOS4005I: Host Power-On password changed by user [arg1] from [arg2] at IP address [arg3].
This message is for the use case where Host Power-On password changed.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0231
User Action:
Information only; no action is required
• FQXSPOS4006I: Host Power-On password cleared by user [arg1] from [arg2] at IP address [arg3].
This message is for the use case where Host Power-On password cleared.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0232
User Action:
Information only; no action is required
• FQXSPOS4007I: Host Admin password changed by user [arg1] from [arg2] at IP address [arg3].
This message is for the use case where Host Admin password changed.
Severity: Info
74
ThinkSystem SR860 Messages and Codes Reference
Advertisement
Table of Contents
