Table of Contents
Advertisement
This message is for the use case where a user modifies the IP subnet mask of a Management Controller.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0010
User Action:
Information only; no action is required
• FQXSPNM4009I: IP address of default gateway modified from [arg1] to [arg2] by user [arg3].
This message is for the use case where a user modifies the default gateway IP address of a Management
Controller.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0011
User Action:
Information only; no action is required
• FQXSPNM4010I: DHCP[[arg1]] failure, no IP address assigned.
This message is for the use case where a DHCP server fails to assign an IP address to a Management
Controller.
Severity: Warning
Serviceable: No
Automatically notify Support: No
Alert Category: System - IMM Network event
SNMP Trap ID: 37
CIM Prefix: IMM CIM ID: 0013
User Action:
Complete the following steps until the problem is solved:
1. Make sure that the XCC network cable is connected.
2. Make sure that there is a DHCP server on the network that can assign an IP address to the XCC.
• FQXSPNM4011I: ENET[[arg1]] DHCP-HSTN=[arg2], DN=[arg3], IP@=[arg4], SN=[arg5], GW@=
[arg6], DNS1@=[arg7] .
This message is for the use case where a Management Controller IP address and configuration has been
assigned by the DHCP server.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - IMM Network event
SNMP Trap ID: 37
CIM Prefix: IMM CIM ID: 0022
User Action:
60
ThinkSystem SR860 Messages and Codes Reference
Advertisement
Table of Contents
