Lenovo 7X69 Manual page 187

a. Disable Secure Boot: assert Physical Presence and then change Secure Boot Setting to Disable (
in F1 Setup -> System Settings -> Security -> Security Boot Configuration -> Security Boot
Setting).
b. Enroll the unauthorized UEFI Image. assert the Physical Presence and then change Secure Boot
Policy to Custom Policy ( in Setup -> System Settings -> Security -> Security Boot Configuration
-> Security Boot Policy), then enter into "Security Boot Custom Policy" Menu, press the "Enroll Efi
Image" button, select the unauthorized UEFI Image in the popup box.
c. NOTE: There're two ways to assert Physical Presence:
1) Switch Physical Presence Jumper to ON;
2) If the Physical Presence Policy has been set to enabled ( F1 Setup -> System Settings ->
Security -> Physical Presence Policy Configuration), user is allowed to assert remote Physical
Presence via IPMI tool.)
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU0023I: Secure Boot Image Verification Failure has been cleared as no failure in this round
boot.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU0024G: Intel UEFI ACM startup failed, make sure TPM is enabled.
Severity: Warning
User Action:
Complete the following steps:
1. Assert Physical Presence via the Physical Presence Jumper or Remote Physical Presence:
2. NOTE: There are two methods to assert Physical Presence:
a. Move the Physical Presence Jumper to the "ON" position.
b. If the "Physical Presence Policy" has been set to "Enable" in F1 Setup the user is allowed to
assert remote Physical Presence via the IPMI tool. The setting can be found in F1 Setup at
"System Settings -> Security -> Physical Presence Policy Configuration".
3. If TPM version is 2.0, go to next step. If TPM version is 1.2, do the following:
a. From the Setup Utility program main interface, select System Settings -> Security -> Trusted
Platform Module.
b. Change [TPM Device] to "Enable".
c. Change [TPM State] to "Activate".
4. Reboot the system.
5. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU0025I: The default system settings have been restored.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU0027N: System uncorrectable error has occurred on Processor [arg1] Core [arg2] MC
bank [arg3] with MC Status [arg4], MC Address [arg5], and MC Misc [arg6].
Severity: Fatal
. 183
Chapter 3 UEFI events