BoomToneDJ Maxi Beam 60 User Manual page 13

Yes-No
rPan
Yes-No
rtILt
rSET
4-Operating modes
3 operating modes available :
1. automatic mode with master/slave function, pre-programmed effects
2. DMX mode - Controlled by a DMX controller
3. Sound mode: music detection
Automatic mode with Master/Slave function, pre-programmed effects.
In Master/Slave mode, the first device controls the subsequent devices. This mode is very
practical when you need a quick installation with immediate results.
The Maxi Beam 60 defaults to "Master mode" if no DMX cable is connected to its DMX
IN input.
Similarly, the Maxi Beam 60 is in "Slave" or "DMX mode" as soon as it receives a DMX
signal on its DMX IN input.
The Maxi Beam 60 "Master" can be configured in Automatic "Simple" mode or
Automatic "Audio" mode. (see table opposite)
DMX mode
Press the "MENU" button, then select function "A001".
Use the "UP" and "DOWN" buttons to select the DMX address value you require.
PAN inversion
Tilt reversal
Reset
13